This e-mail address is being protected from spambots. You need JavaScript enabled to view it.

Monday, 07 November 2011 14:42

E-Z Lock® Threaded Inserts

Rate this item
(0 votes)
E-Z Lock external threads are standard size and pitch to permit use of standard drills and taps. No special tap sizes or installation tools are required. E-Z Lock inserts will not back out or vibrate loose. Immediately upon installation, microencapsulated Loctite® begins to set and the newly installed insert can be fastened to within minutes. In addition, the adhesive seals against liquids and gases to pressures of 6000 psi, and bonds to virtually all metals. METRIC Sizes From M3-M16 (internal thread)
Read 27489 times Last modified on Wednesday, 07 December 2011 16:00

17864 comments

Leave a comment

Make sure you enter the (*) required information where indicated. HTML code is not allowed.